지금 지원 담당자와 채팅
지원 담당자와 채팅

Archive Manager 5.9.6 - Installation and Configuration Guide for GroupWise

Deployment considerations for GroupWise System requirements Hardware recommendations Pre-installation preparations Installing and configuring Archive Manager Upgrading/Uninstalling Archive Manager Post-installation tasks Appendix A: Attachment store types Appendix B: Process overview checklist

Post-installation tasks

•
Configuring Archive Manager
•
Configuring the GroupWise Directory Connector (GDC)
•
Backloading your data
•
Localizing Archive Manager website (optional)

Configuring Archive Manager

After you install Archive Manager, you must perform certain configuration tasks before you can begin to use the product. Most of these necessary post-installation tasks are explained in the contents of this chapter:

•
Configuring the GroupWise Directory Connector (GDC)
•
Backloading your data

In addition to the above-listed tasks, you must also set up at least one Message Policy, and apply a Policy to a mail server or mailboxes.

Detailed instructions can be found in the Archive Manager Administration Guide.

To begin the initial configuration, sign in to the Quest Archive Manager web site. The default administrator account is admin, and the password was specified during installation. Use the domain DEFAULT.

Once you have signed in, click the Administration icon (top-right corner of the window) to go to the administrative section of the Archive Manager web site.

Configuring the GroupWise Directory Connector (GDC)

If you want to modify the defaults for the following configuration settings, add them to the Archive Manager Configuration Console and then modify the default settings.

•
GroupWise Directory Connector Timer Interval: The default value for this setting is 3600 seconds (1 hour). The value is the number of seconds that the GDC will wait after an export run has completed to run the next export
•
GroupWise Directory Connector Reset Timer Interval: The default value for this setting is 600 seconds (10 minutes). The value is the number of seconds that the GDC will wait for a GroupWise API call to finish. If a GroupWise API method fails to return within this time, the GDC will terminate the process and start the export run over from the beginning.

Backloading your data

Before you run the GSM for the first time, complete the following steps to ensure that all of your email data is successfully processed.

1
Add the GroupWise Store Manager Use No Filters configuration setting to the Configuration Console and set the value to True.
2
Start GSM Service to begin the initial backload of your email data.
3
Once all mailboxes have been successfully processed once with the GroupWise Store Manager Use No Filters setting enabled, change the value for the setting to False.
This allows other date filters to take over and process a smaller set of data instead of continually processing the full set of data.
관련 문서

The document was helpful.

평가 결과 선택

I easily found the information I needed.

평가 결과 선택