Receiving "Error 1904. Module C:\program files... Failed to register" during installation of NetControl.
This is a Server 2008 server with User Account Control (UAC) enabled.
Turn off UAC.
1. Start|Control Panel|User Accounts.
2. Click on Turn On or Off User Account Control
3. Uncheck UAC Enabled box.
4. Reboot Server.
1. Run NetControl Server.msi
2. If NetControl Server was partially installed, Remove will be an option. Click Remove.
**Note. You may receive "Error 1905" due to the fact that certain dll's were not installed, thus cannot be found.
3. Run NetControl Server.msi and install NetControl.