2 |
On the Add Storage Devices page, select the Shared virtual tape library option and the Re-add previously generated virtual device check box. |
3 |
In the list of NetVault Backup machines, select the machine on which the device was created. Click Next to scan the selected client and list the discovered SVTLs. |
4 |
6 |
To assign the drives to different clients or to share the drive with multiple clients, click Add Drives Manually, and complete the following steps: |
a |
In the Choose Machine table, select the client to which the drive is attached. If the device is connected to multiple clients, select any one client. Click Next to scan the selected client and list the attached devices. |
b |
c |
If the device is connected to multiple clients (for example, in a SAN setup), all host clients are listed in the Choose Machines table. To share the drive with multiple clients, select the additional clients in the Choose Machines table, and click Next. |
This section includes the following topics:
In NetVault Backup, the Drive Transfer Buffer Size option is set to 8 MiB by default.To ensure that this configuration is supported on your system. If this value is too high, change it to 257 KiB in the template file by , completing the following steps.
1 |
Open the file “drives.tpl” in a text editor. |
2 |
NOTE: If Drive Transfer Buffer Size is set too high and NetVault Backup fails to allocate the transfer buffers, the backup jobs using tape devices show reduced performance. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Termini di utilizzo Privacy Cookie Preference Center