1 |
2 |
3 |
On the NetVault Backup Selections page, double-click the NetVault Backup Server (with the Plug-in Server installed on it) to open it. |
4 |
Double-click the Plug-in Server (labeled “VaultDR APM”) icon to expand it. |
5 |
Select the applicable NetVault Bare Metal Recovery Client, and select Edit Client from the Actions list. |
6 |
When the Edit Bare Metal Recovery Plug-in Offline Client dialog box appears, update the applicable values: |
• |
Client Name: This field contains the current name for the selected client. Changing this value updates the name of the NetVault Bare Metal Recovery Client in NetVault Backup. |
• |
Address(es): This field contains the IP address originally set for this client. You can change this value or add additional, comma-separated addresses. |
• |
Port Number: This field contains the port used to invoke drdaemon (for example, 15555). The default is 10000. |
• |
NDMP Protocol: This field determines whether to use the Network Data Management Protocol (NDMP) during backup and restore jobs. The default is FALSE. If you are using the Plug-in Offline Client for Linux, the protocol must be set to TRUE. |
1 |
2 |
3 |
On the NetVault Backup Selections page, double-click the NetVault Backup Server (with the Plug-in Server installed on it) to open it. |
4 |
Double-click the Plug-in Server (labeled “VaultDR APM”). |
5 |
• |
IMPORTANT: If the target NetVault Bare Metal Recovery Client is configured with multiple NIC/SCSI devices for access, Dell recommends that you gather the preceding information for each device. The Plug-in Offline Client boot process recognizes all these devices and requests that you configure each, individually, with this information (but only one of the devices actually needs to be configured successfully for use). |
3 |
5 |
In the content that is revealed, locate and record the Gateway value (when the command is issued, this value is revealed as the default value). |
3 |
In the content that is revealed, locate and record the IP Address, Subnet Mask (Network Mask), and Default Gateway values. |
2 |
Press Enter to start the sequence immediately. |
3 |
4 |
In the Editing Network Interface dialog box, configure the IPv4 and IPv6 settings for the selected network interface. |
5 |
When you are finished, press Apply to return to the Network Connections dialog box, and then press Close. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Términos de uso Privacidad Cookie Preference Center