The SnapVault Password Utility svpassword allows you to set the NetVault Backup user account and password in the SnapVault Manager configuration file to enable communication between the Plug‑in for SnapVault Manager and NetVault Backup Server. This utility must be used if the password is changed for the “default” or “admin” user accounts.
The svpassword utility is located in the netvault/bin directory on the NetVault Backup Server on which the Plug‑in for SnapVault Manager is installed.
The <old password> parameter can be omitted if no password was set for the user account.
For example, if the password for the “default” account has been changed to “test” in NetVault Backup, type the following command to set the password in the SnapVault Manager configuration file.
The procedure for transferring backup data includes the steps outlined in the following sections:
1 |
In the Navigation pane, click Create Backup Job. |
2 |
3 |
Open the NetVault Backup Server, and then open SnapVault Manager. |
4 |
Open SV Secondaries, and select the volume that is to serve as storage space for SV Primary backups. |
5 |
6 |
In the Add Secondary Service dialog box, configure the following options. |
This check box is selected by default. It indicates that this Service is enabled after it is created. To disable the service, clear this check box from the Edit Service window. | |
Specify the maximum number of snapshots to be held in the selected volume before recycling occurs. | |
This setting specifies the date and time when the updates (Incremental Backups) begin. | |
Select the hours of the day at which updates are to occur. If you do not select any Days or Hours check boxes, only a single update is performed at the time and date specified in the Run From box. |
© ALL RIGHTS RESERVED. Términos de uso Privacidad Cookie Preference Center