Regresar
-
Título
Cannot use mode hotadd to access [XXXX-XXXXXX] Test-client/test-client-new.vmdk: Cannot mount using this method. (Mounting XXXXXa24-1662-f7d2-d77b-9906a0axxxxx using transport hotadd failed : Could not locate device nodes for new disks..) -
Descripción
You can add a VMware Paravirtual SCSI high performance storage controller to provide greater throughput and lower CPU utilization. This applies in scenarios where multiple proxies are being used across the network.
VMware Paravirtual SCSI controllers are best suited for environments, especially SAN environments, that run I/O-intensive applications and a lot of data every day.. -
Resolución
Steps for configuring Paravirtual SCSI Controller.
There are some additional steps to avoid the vm not booting up after changing of lSI SAS for an existing controller/boot disk.
dracut command creates an initial image used by the kernel for preloading the block device modules (such as IDE, SCSI or RAID) which are needed to access the root filesystem, mounting the root filesystem and booting into the real system.
Take a look at the steps that must be configured on the vm.
- dracut -N -f.
- Power down vm
- Change primary controller to vmware paravirtual with the next steps
- Click Virtual Machines in the VMware Host Client inventory.
- Right-click a virtual machine in the list and select Edit settings from the pop-up menu.
- On the Virtual Hardware tab, click Add other device and select SCSI Controller from the drop-down menu.
- The new SCSI Controllers appear in the Hardware list.
- Click the New SCSI Controller and select VMware Paravirtual from the drop-down menu.
- Click Save.
- Power up -- should come up clean
- dracut -f --regenerate-all
These steps only applies to Red Hat distros. Here is an article from VMware with more information about this configuration.
https://kb.vmware.com/s/article/1010398
The VMware User's guide will be updated with this information in the next release version of the software.