The GlobalView feature is available on all DR Series systems that have version 3.0.0.1 (or later) software installed. The system to which you are currently logged in is automatically included by default in the GlobalView page; however, any other systems must be explicitly added. For details, see Adding a DR Series System to Global View.
To view and use the GlobalView page, follow these steps.
The following table describes the information that is displayed in the GlobalView Summary.
Displays the system operational state as an icon.
| |||||
Displays the used physical storage capacity as a percentage. | |||||
Displays the total savings as a percentage (combining both deduplication and compression). | |||||
Displays the alert count. You can click the number to navigate to the Alerts page. | |||||
Displays the replication state as an icon.
| |||||
Displays the rate of data being written to the DR Series system across your network in MiB/s. |
◦ |
◦ |
6. |
To go back to viewing the managing DR Series system, click the Return to Managing Unit link, which appears above the GlobalView menu item in the left navigation menu. |
To add a DR Series system to Global View, complete the following steps:
2. |
On the Global View page, click the Action menu in the upper right corner, and then click Add to Global View. |
3. |
In the field, DR Unit FQDN or IP address, add the fully-qualified domain name (FQDN) or IP address of the DR Series system that you want to add. |
4. |
In the Username field, enter the domain user name for the DR Series system that you want to add. For example, DOMAIN\administrator. This entry should be identical to the credentials used in all other systems in the GlobalView. |
5. |
In the Password field, enter the domain password for the DR Series system that you want to add. This entry should be identical to the credentials used in all other systems in the GlobalView. |
6. |
When you remove a DR Series system from GlobalView on one system, it does not remove it from any other GlobalViews to which you may have added it on other systems.
To remove a DR Series system from GlobalView, complete the following steps:
2. |
On the GlobalView page, in the appliance list, click the Delete icon next to the system you want to delete. |
3. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Nutzungsbedingungen Datenschutz Cookie Preference Center