Prior to downloading this Software, you must review the Software Transaction Agreement located here and confirm, by clicking the I agree check box below, that your organization accepts and is bound by the terms and conditions of the Software Transaction Agreement for this Software.
If you purchased the licenses for this Software by executing an order form with Quest or if you have an agreement with Quest that states that all purchases are governed by such agreement, then the terms and conditions of that agreement supersedes and takes precedence over the Software Transaction Agreement.
SAP Hana Database Error: sql syntax error: incorrect syntax near..." error message encountered when executing block statement with a Temp table, using SAP Hana connectionRepro Steps - Start TDP and establish SAP Hana connectionOpen SQL Editor and paste following statement: “DO BEGIN TESTTABLE=SELECT 'HELLO WORLD!' FROM DUMMY; SELECT * FROM :TESTTABLE; -- this line creates a syntax...
As a new TDP installation in a new computer, you should do manually all the named queries, since only you will have the default set up and that task will consume a lot of time.
Toad Data Point is a multi-platform database query tool built for anyone who needs to access data, understand data relationships, and quickly produce reports. Note: This installer can be used for support of 32-bit or 64-bit drivers. What's the difference between the 32 and 64 bit Toad Data Point Installation?
The .MSI installer is used for silent installation, which provides a convenient method for corporate deployment to multiple machines that use the same settings or installation directory. Refer to the Toad Data Point Installation Guide for advantages and disadvantages of the .MSI installer. Note: This installer is the msi version of the install, used for support of just 64-bit drivers.
The .MSI installer is used for silent installation, which provides a convenient method for corporate deployment to multiple machines that use the same settings or installation directory. Refer to the Toad Data Point Installation Guide for advantages and disadvantages of the .MSI installer. Note: This installer is the msi version of the install, used for support of just 32-bit drivers.
Get the message "You need to install Microsot Active Directory Authentication Library (adalsql.msi) to connect to Azure SQL Database using Active Direcory Password Authentication" in Toad Data Point
When trying to upgrade from 6.2.0.23226 to 6.2.3.25681, the installer asks me first to remove the previous version.Is that correct? Will the settings be preserved even though I remove the previous version?
If query using CTE is run using an ODBC connection to an IMPALA Data source, it will produce and error related to Syntax. If the query is run without using CTE it will run fine.
The query builder has only two tabs rather than three. I have 'diagram' and 'results', but the 'query' tab is no longer showing. How do I get it back ?
In the old Toad, every SQL table I’d open up would give a count of records in the lower right, like so: But opening the same table in 6.2, and it’s just blank: What’s especially weird is that I do get the Record count like normally if I’m viewing a query I built, but not in any of the Tables or Views. Is there a setting somewhere I need to change?