立即与支持人员聊天
与支持团队交流

vRanger 7.7.1 - Integration Guide for NetVault SmartDisk

Getting started Understanding NetVault SmartDisk Planning your NetVault SmartDisk deployment Installing vRanger Installing NetVault SmartDisk Configuring NetVault SmartDisk Monitoring NetVault SmartDisk About us

Prerequisites for reinstalling NetVault SmartDisk

Previous Next


Installing NetVault SmartDisk > Reinstalling NetVault SmartDisk > Prerequisites for reinstalling NetVault SmartDisk

Prerequisites for reinstalling NetVault SmartDisk

Ensure that the following prerequisites are met before reinstalling the NetVault SmartDisk software binaries.

The original identity.cfg configuration file is available. This file is located in the following directory:

…\diskmanager\etc

Reinstalling NetVault SmartDisk if identity.cfg is available

Previous Next


Installing NetVault SmartDisk > Reinstalling NetVault SmartDisk > Reinstalling NetVault SmartDisk if identity.cfg is available

Reinstalling NetVault SmartDisk if identity.cfg is available

If the original identity.cfg configuration file is available, reinstall the NetVault SmartDisk software binaries by performing the following steps:

For more information, see Authentication requirements.

During installation, enter the original values for the following options:

For more information, see Installing the NetVault SmartDisk software.

For more information, see Updating the Storage Pool directory structure.

For more information, see Stopping NetVault SmartDisk Services.

5
Replace the identity.cfg file with the original file.

This file is located in the following directory:

…\diskmanager\etc

For more information, see Starting NetVault SmartDisk Services.

Reinstalling NetVault SmartDisk if identity.cfg is not available

Previous Next


Installing NetVault SmartDisk > Reinstalling NetVault SmartDisk > Reinstalling NetVault SmartDisk if identity.cfg is not available

Reinstalling NetVault SmartDisk if identity.cfg is not available

If the original identity.cfg configuration file is not available, reinstall the NetVault SmartDisk software binaries by performing the following steps:

For more information, see Authentication requirements.

During installation, enter the original values for the following options:

For more information, see Authentication requirements.

For more information, see Updating the Storage Pool directory structure.

For more information, see Stopping NetVault SmartDisk Services.

For more information, see Starting NetVault SmartDisk Services.

Configuring NetVault SmartDisk

Previous Next



Configuring NetVault SmartDisk ports for communication with your software

By default, NetVault SmartDisk uses port 37453 to communicate with vRanger instances that are streaming data to the NetVault SmartDisk Device. It also uses port 37451 for Inter Process Communication (IPC) on the loopback interface, but not for remote connections.

相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级