power on the DR Series system.
• |
In the DR Series system GUI, add and activate the expansion shelf enclosure on the Storage page (as described in the steps below). |
To add an expansion shelf to the DR Series system, complete the following steps:
1. |
2. |
In the Physical Storage pane, click Add in the Configured column of the Physical Storage summary table that corresponds to the enclosure you want to add (Not Configured is the displayed State for the enclosure). |
3. |
4. |
If you clicked OK, an Enclosure Addition dialog box is displayed that indicates this process may take up to 10 minutes to complete. |
5. |
NOTE: If the Enclosure tab does not display a green status check mark, this indicates that there is an issue with the enclosure (such as it has not been properly connected or activated). |
6. |
NOTE: The topics in this section apply to physical DR Series systems. For information about setting up the virtual DR Series system, DR2000v, see the Dell DR2000v Deployment Guide for your specific VM platform and the Dell DR Series System Interoperability Guide. For more information on the DR Series system CLI commands, see the Dell DR Series System Command Line Reference Guide. |
Refer to the following topics for information about setting up the DR Series system hardware.
You can create and manage containers that are the repositories where you store your backup and deduplicated data. A data container is a shared file system that is imported using a client, and is accessible via file system protocols. For details, see Supported File System Protocols. A data container can also be a virtual tape library (VTL) type container.
• |
IP Addresses: You need to make sure to have IP addresses that you use for the DR Series system. The DR Series system ships with a default IP address and subnet mask address, which should only be used for an initial system configuration. |
To perform an initial configuration, you need:
• |
NIC Connections: To configure NIC connection bonding remember that, by default, the DR Series system will configure its NIC interfaces together as a bonded team (and only one IP address is needed because the bonded NICs assume the primary interface address). NIC connection bonding can use either of these configurations: |
◦ |
For more information about replication ports, see Managing Replication Operations, and for more information about system ports, see Supported Ports in a DR Series System.
NOTE: For the latest details about supported hardware and software for the Dell DR Series system, see the Dell DR Series System Interoperability Guide at support.dell.com/manuals. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. 使用条款 隐私 Cookie Preference Center