NetVault Bare Metal Recovery 11.1 - Release Notes for Linux Offline Client Plug-in


	IMPORTANT: Starting with 10.0, NetVault Backup provides a web-based user interface (WebUI) to configure, manage, and monitor your NetVault Backup system. The procedures described in the user’s guide for this version of the product are intended for the new WebUI. For procedures based on the NetVault Backup Console (user interface available with NetVault Backup 9.x), see the documentation for an earlier version of the product.

Table 1. General resolved issues
Resolved issue	Issue ID
Corrected an issue that prevented the SCSI Generic (SG) driver from loading automatically when a physical tape device is detected.	31092

Table 2. General known issues
Known issue	Issue ID
Proprietary driver support: Plug-in Offline Client, which is based on Red Hat® Enterprise Linux® (RHEL) Rescue mode, includes support options that are limited by RHEL. However, you can install drivers on your own RescueCD/RescueUSB device to restore your environment.	17898 (VDG‑187)
Backing up Dynamic Disks is only supported by using Disk Raw Mode.	17966 (VDG‑252)
Restoring a GPT partition table to a larger disk results in a new partition that is the same size as the original: When a DR image is taken, the partition table is stored with it. At restore time, this partition is written to the new target disk and re-creates the original disk. If you restore to a disk that is larger than the original, the disk is partitioned to match the original size, which can result in unused disk space. For example, if you restore a 100GB image to a 200GB disk, it is partitioned for 100GB and leaves the extra space unused. You can use third-party partitioning tools, such as GNU Parted or PartitionMagic, to correct this issue.	17967 (VDG‑253)
Restarting a machine that was booted using VaultOS intermittently causes a General Protection Fault. If you restart the machine, it should boot normally.	24236
After you restore a Windows Server® 2012 system, the system displays the Recovery screen the first time that you start it. You can either select See advanced repair options > Continue or Restart my PC to finish bringing up the client.	30737