立即与支持人员聊天
与支持团队交流

NetVault Plug-in for VMware 10.0.5 - User Guide

Introduction Installing the plug-in Configuring the plug-in Defining a backup strategy Using the image-level backup method Using the file-level backup method Restoring image-level backups Restoring file-level backups Troubleshooting

Additional notes

To create the first Full Backup of a virtual machine with Changed Block Tracking enabled, the target virtual machine must be powered off to enable CBT. For more information, see http://kb.vmware.com/kb/1031873. The virtual machine can be restarted as soon as the backup starts transferring data.
The re-configuration of Changed Block Tracking takes effect only after the virtual machine goes through a stun and unstun cycle, including power-on, resume after suspend, migrate, or snapshot create, delete, or revert operations.
Creates a non-CBT Full Backup, unless CBT is already enabled for the virtual machine or you have selected the Enable Change Block Tracking for VM check box for the Incremental or Differential Backup.
Log message: Failed to write index of backup to the database.
Log context: The index for this backup may be retrieved and added to the database by scanning the backup media.

Backup selection tree icons

Resetting CBT on a virtual machine

1
Start the Backup Job Wizard, and click Create New next to the Selections list.
4
Select the target virtual machine, and in the Actions list, click Reset Change Block Tracking.
Log message: Failed to determine disk areas to backup.
Log context: A specified parameter was not correct. deviceKey.

Monitoring job progress

3
On the Monitor Job page, you can view the following information.
Job details: This area displays the Job ID, title, phase, instance, client, plug-in, start time, expected completion time, run count, duration, size, and status.
Data transfer chart: This area displays the data transfer chart.
Job logs: This area displays the log messages.
相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级