立即与支持人员聊天
与支持团队交流

NetVault Plug-in for SnapVault Manager 10.0.1 - User Guide

Using SnapVault password utility

The SnapVault Password Utility svpassword allows you to set the NetVault Backup user account and password in the SnapVault Manager configuration file to enable communication between the Plug‑in for SnapVault Manager and NetVault Backup Server. This utility must be used if the password is changed for the “default” or “admin” user accounts.

The svpassword utility is located in the netvault/bin directory on the NetVault Backup Server on which the Plug‑in for SnapVault Manager is installed.

Syntax
svpassword <account> <old password> <new password>

The <old password> parameter can be omitted if no password was set for the user account.

For example, if the password for the “default” account has been changed to “test” in NetVault Backup, type the following command to set the password in the SnapVault Manager configuration file.

./svpassword default test

Generating snapshots

•
Transferring backup data
•
Available commands in the Actions list
•
ASIS deduplication of secondary snapshots

Transferring backup data

The procedure for transferring backup data includes the steps outlined in the following sections:

•
Establishing service on SV Secondary
•
Establishing relationship on SV Primary
•
Initial synchronization and updates

Establishing service on SV Secondary

The first step involves creating the SnapVault Snapshot Schedule (referred to as “Service” within the Plug‑in for SnapVault Manager) on the SV Secondary. This schedule allows generation of snapshots for the SV Primary data at scheduled intervals. These snapshots are held on the SV Secondary system.

1
In the Navigation pane, click Create Backup Job.
– or –
In the Navigation pane, click Guided Configuration, and then on the NetVault Configuration Wizard page, click Create Backup Jobs.
2
To open the NetVault Backup Selections page, click Create New next to the Selections list.
3
Open the NetVault Backup Server, and then open SnapVault Manager.
4
Open SV Secondaries, and select the volume that is to serve as storage space for SV Primary backups.
5
In the Actions list, click Add Service.
6
In the Add Secondary Service dialog box, configure the following options.
Option
Description

Name

Type a name for the Service. Valid characters include, A–Z, 0–9, “-” (hyphen), and “_” (underscore). This field is required. After the Service is successfully configured, this name is how it is displayed in NetVault Backup when creating a Relationship between it and an SV Primary.

Enabled

This check box is selected by default. It indicates that this Service is enabled after it is created. To disable the service, clear this check box from the Edit Service window.

Secondary Retention Count

Specify the maximum number of snapshots to be held in the selected volume before recycling occurs.

Default Primary Update Offset

This setting specifies the number of minutes before updates occur for an SV Primary that has established a relationship with this service.

Run From

This setting specifies the date and time when the updates (Incremental Backups) begin.

Days

Select the days of the week on which updates are to occur.

Hours

Select the hours of the day at which updates are to occur. If you do not select any Days or Hours check boxes, only a single update is performed at the time and date specified in the Run From box.

7
To add the Service to the SV Secondary node, click OK.
It is displayed under the volume for which it was set up. The icon is marked by a yellow “S” and labeled with its title.
相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级