◦ |
For local devices, go to the BIOS on the target device and select Network Controller to network boot the target device in to the KBE. |
◦ |
Graphical Menu: Supports selecting options using arrow keys. |
◦ |
Text Menu: Supports older NICs that do not support integrated graphics, but allows using arrow keys. |
◦ |
Basic Menu: Supports NICs that do not have integrated graphic support and cannot recognize arrow keys. |
You can perform scripted installation or system image deployments manually from the KBE Main Menu.
2. |
3. |
4. |
Ensure the Restart Automatically after deployment check box is selected to reboot the device after the image is applied. |
b. |
On the left navigation pane, click Settings > Control Panel to display the Control Panel, then click General Settings to display the General Settings page. |
c. |
Under Imaging Options, select the Default setting to automatically reboot after manual deployment check box. Select this check box if you want the target system to reboot automatically after a manual deployment. |
d. |
5. |
1. |
On the left navigation pane, click Progress, then click Manual Deployments to display the Manual Deployment Progress page. |
2. |
3. |
In the Devices menu bar, click Details next to the device MAC address to view the progress of the tasks that are running for the deployment. |
1. |
On the left navigation pane, click Audit Log to expand the section, then click Manual Deployments to display the Manual Deployment Log page. |
2. |
3. |
In the Devices menu bar, click Details next to the device MAC address to view the success or failure of the tasks there were run for the deployment. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback 使用条款 隐私 Cookie Preference Center