立即与支持人员聊天
与支持团队交流

Foglight for Storage Management Shared 4.6.5 - Installation Guide

Getting Started Configuring Agents to Monitor Storage Devices
Brocade SAN Switches Cisco SAN Switches Dell Compellent Arrays Dell EqualLogic PS Series Array Groups EMC CLARiiON CX Series Arrays (CLI) EMC CLARiiON, VNX, or VMAX Storage Arrays (SMI-S) EMC Isilon EMC VPLEX Hitachi Data Systems AMS, USP, and VSP HP EVA Storage Arrays HP 3PAR Arrays NetApp Filers Collection Target Support Matrix Configuration Procedures
Managing Agents

Configuring Agents to Monitor Storage Devices

This section contains the supported storage devices by vendor, requirements for each device, and procedures to help you complete the screens in the Storage Device Setup dialog box.

This section includes the following topics:

•
Brocade SAN Switches
•
Cisco SAN Switches
•
Dell Compellent Arrays
•
Dell EqualLogic PS Series Array Groups
•
EMC CLARiiON CX Series Arrays (CLI)
•
EMC CLARiiON, VNX, or VMAX Storage Arrays (SMI-S)
•
EMC Isilon
•
EMC VPLEX
•
Hitachi Data Systems AMS, USP, and VSP
•
HP EVA Storage Arrays
•
HP 3PAR Arrays
•
NetApp Filers
•
Configuration Procedures

Brocade SAN Switches

Foglight for Storage Management uses the SMI-S interface to collect from Brocade SAN switches.

Brocade switch information is collected using the following namespaces:

•
Interop Namespace — interop
•
Working Namespace(Brocade) — root/brocade1
•
Working Namespace(McData) — root/mcdata

Foglight for Storage Management executes the following SMI-S commands to obtain switch information on all SAN switches or Switch Management applications:

•
EnumerateInstanceNames
•
EnumerateInstances
•
References
•
Reference Names
•
Associators
•
Associator Names
•
GetClass

For more information, see the following topics:

•
Requirements for Brocade SAN Switches
•
Configuring Agents to Monitor Brocade SAN Switches

Requirements for Brocade SAN Switches

Requirements differ depending on the version of Brocade Fabric OS (FOS) used by your switch.

Brocade Switches on FOS 7.0 or later

For Brocade switches running FOS 7.0 or later, Foglight for Storage Management collects information from the switches using the Brocade Network Advisor (BNA). Foglight for Storage Management works with either the full commercial version of BNA (license required) or the SMI-S only version of BNA (free).

Your environment must meet the following requirements:

•
Brocade Network Advisor is installed, either the full version or the free SMI-S Only mode version.
•
Brocade switches are not configured as Access Gateway switches. Foglight for Storage Management does not collect from switches configured as Access Gateway switches.
•
Foglight for Storage Management requires a user account with read access. An account with write/admin access is required to add the switch to BNA, but is not required for monitoring.
相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级