Before installing this version of Code Tester, ensure that your system meets the following minimum hardware and software requirements.
Requirement |
Details |
---|---|
Memory |
Note: The memory required may vary based on the following:
|
Hard disk space |
|
Operating system |
|
Table 1: Database requirements
Requirement |
Details | ||
---|---|---|---|
Database client |
An Oracle client must be installed and configured on the system where you are running Code Tester. The following are supported:
Note: You must use the 32-bit version of Code Tester with the 32-bit Oracle client, and the 64-bit version of Code Tester with the 64-bit Oracle client. | ||
Database server |
Oracle versions:
Exadata: Code Tester has been tested on Oracle Exadata 2.0 running Oracle database 11g R2. Important: It is recommended that your client version be of the same release (or later) as your database server. This is an Oracle recommendation to prevent performance issues. | ||
Cloud database server | Oracle Database as a Service on Amazon EC2 and Oracle Cloud. | ||
Database privileges |
The schema in which you install Code Tester must have these privileges: CREATE PROCEDURE CREATE SEQUENCE CREATE SESSION CREATE SYNONYM CREATE TABLE CREATE TRIGGER CREATE VIEW CREATE TYPE | ||
|
Internet Protocol Version 6 (IPv6) is being adopted by the US Federal Government and industries around the world. In its most basic format, the new protocol uses 128-bit addresses instead of 32-bit addresses, which are used by the current IPv4 to route packets over the Internet. Code Tester for Oracle features, such as FTP, access the Internet through third-party vendors that are IPv6 compliant, such as /nSoftware's IP*Works.
Before installing Code Tester for Oracle, review the following for virtualization support:
| |||
|
To activate a trial license
Open the Licensing dialog: Help | Licensing.
Click Modify and enter the new license key and site message.
To activate a purchased commercial license
Open the Licensing dialog: Help | Licensing.
Click Modify and enter the new license key and site message.
See the online help for topics that will help you begin using Code Tester for Oracle.
Refer to Code Tester for Oracle Installation and Configuration Guide for installation instructions.
Additional information about Code Tester for Oracle is available on Toad World.
This section contains information about installing and operating this product in non-English configurations, such as those needed by customers outside of North America. This section does not replace the materials about supported platforms and configurations found elsewhere in the product documentation.
This release is Unicode-enabled and supports any character set. In this release, all product components should be configured to use the same or compatible character encodings and should be installed to use the same locale and regional options. This release is targeted to support operations in the following regions: North America, Western Europe and Latin America, Central and Eastern Europe, Far-East Asia, Japan.
© ALL RIGHTS RESERVED. 使用条款 隐私 Cookie Preference Center