返回
-
标题
PCIe Link Training Failure is Observed in PCIe Slot 4 -
说明
When setting up the DR4300, the start up displayed PCIe Link Training Failure is Observed in PCIe Slot 4 and the Link is Disabled? -
原因
PCI card in slot 4 maybe bad. Be advised the IDRAC may not report of a part in slot 4, probably because the part is bad and not registering. A TSR and dset could not report the anything for the slot in question to aid in identifying the issue or the part in the slot.Physically on the system is the only sure fire way of identifying the part however if the system is located elsewhere more than likely the component is a NVRAM/MARVELL/ADPT/W2PWA/Controller Quest part number 5KVY3 equivalent to Dell part number WG0YWTry reseeding the part or moving it to another slot if possible as part of troubleshooting. Also attempt a power down recycle sequence1. Power down2. Unplug power cord3. Hold down power button for 10 seconds4. Plug in power cord5. Power up -
解决办法
Replace the NVRAM/MARVELL/ADPT/W2PWA/Controller Quest part number 5KVY3 equivalent to Dell part number WG0YW