Chat now with support
Chat with Support

vRanger 7.8 - Integration Guide for DR Series Disk Backup Appliance

Logging in and initializing the DR Series

Previous Next



Use the DR Series system CLI and the Initial System Configuration Wizard to log in to and initialize the system. After completing a local console or iDRAC connection, log in to the DR Series system CLI:
2
At the login as: prompt, type administrator, and press Enter.
3
At the administrator@<system_name> password: prompt, type the default administrator password, St0r@ge!, and press Enter.
4
To configure the network settings, type y (for yes), and press Enter.
5
At the prompt, type exit, and press Enter to end the DR Series system CLI session.

Registering and configuring your DR Series

Previous Next


Installing and configuring your Quest DR Series > Registering and configuring your DR Series

Logging in to the web interface

Previous Next



NOTE: If you want to reset your login password, click Reset Password on the DR Series System Login page. The Reset Password dialog box is displayed. The reset options displayed depend on the password reset option you configured earlier. By default, the service tag option is displayed. In Service Tag, enter the service tag number ID for the system, and click Reset Password to reset the system password back to its default — or click Cancel to return to the DR Series System Login page.
2
In Password, type St0r@ge!, and click Log in or press Enter.
The Customer Registration and Notification page is displayed.

Registering your DR Series

Previous Next



1
In the Settings pane of the Customer Registration and Notification page, complete the following:
In Contact Name, enter a system contact name.
In Relay Host, enter a host name or IP address for the relay host.
In Email Address, enter an email address for the contact.
To be notified about system appliance alerts, select Notify me of DR Series appliance alerts.
To be notified about system software updates, select Notify me of DR Series software updates.
To be notified about container statistics daily, select Notify me of <DR Series> daily container stats reports.
To prevent display of the Customer Registration and Notification page again, select Don’t show me this again.
2
Click Confirm to have the DR Series system accept your settings — or click Skip without configuring any settings — to proceed with initialization.
The Initial System Configuration Wizard page is displayed.
Related Documents

The document was helpful.

Select Rating

I easily found the information I needed.

Select Rating