2 The connectors on the back of your system have icons indicating which cable to plug into each connector. Be sure to tighten any screws on the monitor’s cable connector.
5 Bend the system power cable or cables, as shown in the Quest DR Series Getting Started Guide, and attach to the cable strap.
Before you can start using the DR Series system GUI for the first time, you must properly initialize the system. To initialize the DR Series system, complete the following:
2 Configure your system network settings using the Initial System Configuration Wizard.This wizard lets you configure the following network settings to complete a first-time initialization of your system:
To configure a local console connection, you must make the following two back chassis cable connections:
IMPORTANT: For more information, including port diagrams, see the Quest DR Series System Administrator Guide.
The iDRAC connection requires a network connection between the integrated Quest Remote Access Control (iDRAC) management port on the DR Series system and another computer running the iDRAC remote console session in a supported browser. The iDRAC provides remote console redirection, power control, and the out-of-band (OOB) system management functions for the DR Series system. iDRAC connections are configured using console redirection and the iDRAC6/7 web interface. The login values you can use for making iDRAC connections are:
NOTE: For information on how to configure the iDRAC, see the Dell RACADM Command Line Reference Guide at http://www.dell.com/support/home.