NetVault Plug-in for SAP on Oracle 11.4.5 - Release Notes

Installing a license key from the Manage Clients page

Upgrade and installation instructions

Upgrading from 4.x or earlier is not supported. If you have an existing installation and you might need to restore associated data using the previous version, archive the applicable machine with the existing plug-in and associated data. After you have archived the preceding components, remove the existing plug-in and install the new version. Alternatively, you can install NetVault Backup 8.6.1 (or later) and the Plug‑in for SAP on Oracle 11.4.5 on a new machine, and run both machines until the earlier machine can be retired. (3140)

For upgrade and installation instructions, see the Quest NetVault Backup Plug‑in for SAP on Oracle User’s Guide.

IMPORTANT: The plug-in must exist on the NetVault Backup Server, regardless of the configuration in use. If you are using the recommended Client/Server configuration, complete this process on the SAP Backint Server machine and then repeat the process on the NetVault Backup Server.

More resources

Additional information is available from the following:

Globalization

This section contains information about installing and operating this product in non-English configurations, such as those needed by customers outside of North America. This section does not replace the materials about supported platforms and configurations found elsewhere in the product documentation.

This release supports any single-byte or multi-byte character set. It supports simultaneous operation with multilingual data. This release is targeted to support operations in the following regions: North America, Western Europe and Latin America, Central and Eastern Europe, Far-East Asia, Japan.