지금 지원 담당자와 채팅
지원 담당자와 채팅

NetVault Plug-in for SnapMirror to Tape 13.3 - Users Guide

Upgrading the plug-in

To upgrade the plug-in, follow the steps in the section Installing the plug-in. You can upgrade the plug-in without removing the current version.

To apply new configuration values after an upgrade, open the NetVault Backup WebUI, and browse the plug-in node. On Linux x86-64 platforms, restart the NetVault Backup Service.

Removing the plug-in

1
In the Navigation pane, click Manage Clients.
2
In the NetVault Backup Clients list, select the client on which the plug-in is installed, and click Manage.
3
In the Installed Plug-ins table, select NDMP SnapMirror to Tape Plugin, and click the Remove Plugin button ().
4
In the confirmation dialog box, click Remove.

Configuring the plug-in

•
Prerequisites
•
Adding a NetApp filer
•
Configuring NetVault Backup user account
•
Configuring default settings
•
Configuring media block size

Prerequisites

Before you start the configuration procedure, verify that the following requirements are met:

•
Connect the backup devices: Depending on the Data Transfer Model that you are using, connect the backup device to the NetVault Backup Server, Client, or NetApp filer.
•
Add the NetApp filer: Add the NetApp filer as an NDMP Server to the Plug-in for NDMP. For more information, see the Quest NetVault Backup Plug-in for NDMP User's Guide.
•
In a filer-to-filer data transfer model, add both the target filer and the filer to which the backup device is connected to as NDMP Servers.
•
Add the backup devices: Add the backup device to the NetVault Backup Server if the device is connected to a filer or NetVault Backup Client. For more information about adding devices, see the Quest NetVault Backup Administrator’s Guide.
•
Enable UTF-8 encoding: To use UTF-8 encoding, do the following:
1
Enable UTF-8 encoding on the filer and each target volume.
2
Configure appropriate language-type on each target volume.
To determine if UTF-8 encoding is supported on the target filer and for instructions on configuring Character Set Encoding on the filer, see the relevant filer documentation.
•
Verify that the NDMP service is set to Storage Virtual Machine (SVM)-scoped mode on Clustered Data ONTAP 8.3 or later: On Clustered Data ONTAP 8.3 or later, SMTape backups and restores are only supported in SVM-scoped NDMP mode.
관련 문서

The document was helpful.

평가 결과 선택

I easily found the information I needed.

평가 결과 선택