지금 지원 담당자와 채팅
지원 담당자와 채팅

Foglight 5.9.8 - Installing Foglight on Windows with an Embedded PostgreSQL Database

Before Installing Foglight Installing Foglight
Preparing to install Installing a new version of the Management Server Installed directories Foglight settings Uninstalling Foglight Upgrading the Management Server
Running the Management Server Installing and Upgrading Cartridges Installing Agents Appendix: Switching from an Embedded to an External Database

Uninstalling Foglight

You can uninstall Foglight using the uninstaller utility for your platform. The uninstaller can be found in <foglight_home>\UninstallerData.

The default mode for the uninstaller is the graphical user interface (GUI) mode. However, in cases where a graphics display is not available, the Foglight installer can be run from the command line by using the silent uninstaller.

2
Navigate to the UninstallerData directory of your Foglight installation and run the Uninstall Foglight executable.
To launch the uninstaller in silent mode, run the Uninstall Foglight executable using the following command:
”Uninstall Foglight.exe” -i silent -f installvariables.properties
3
After uninstallation, you can safely delete the <foglight_home> directory. It is recommended that you do so, since the uninstaller does not remove certain directories within <foglight_home>.

Upgrading the Management Server

See the Upgrade Guide for detailed upgrade instructions.

 

Running the Management Server

The instructions in this section assume that you have already installed Foglight. If you have not, see Installing Foglight for installation instructions.

For more details, see these topics:

Initializing the database

If you are using the embedded database, the PostgreSQL® database is installed and initialed during the installation.

관련 문서

The document was helpful.

평가 결과 선택

I easily found the information I needed.

평가 결과 선택