There are two workarounds to tackle this issue:
1- Create a new KBE with the following command set to be executed after WinPE loads:
REG ADD HKCU\Console /v ForceV2 /t REG_DWORD /d 0 /f
This is achieved with Media Manager, in the last tab: DOS Commands, right before uploading the new KBE.
2- Within the KBE (booted and loaded):
-Open CMD (Troubleshooting Tools)
-Open taskmgr
-End the winvnc process
-Run the previous command in CMD
-Start the winvnc process again (from Y:\hta\amd64\ultravnc\startvnc.bat)
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Terms of Use Privacy Cookie Preference Center