In the new SMA 12.0 and later, to change the default "service accounts" password go to the console and log in as netdiag. Observe 4 new commands added in the right column.
To change the password run the “set_netdiag_passwd” command and use any desired character combination as the new password. ie. "abcABC123!@#$%" (without quote marks)
Note: A valid password should be a mix of upper and lower case letters, digits and other characters and will undergo a security strength check.
To reset the netdiag or konfig new password, proceed to run the "reset_konfig_passwd" command. Log out and try logging in as netdiag with the default password.
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Terms of Use Privacy Cookie Preference Center