You can capture UEFI images, WIM images, and K-Images after you boot the device with the image that you want to capture in to the KACE Boot Environment (KBE). The KBE Main Menu loads on to the device when the device boots in to the KBE. You capture images from the device using the KBE Main Menu. You can verify that there is enough disk space on the appliance for the image and prepare the image for capture.
The Quest KACE Support team provides best practices for capturing images. For more information, see, https://support.quest.com/kace-systems-deployment-appliance/kb/121734.
Best practices to prepare for capturing images for deployment:
1. |
Boot the device with the image that you want to capture in to the KBE. From the KBE Main Menu on the device, click Imaging. |
2. |
3. |
4. |
5. |
6. |
Click Force continue on errors to continue the capture and the upload process even if warnings and fatal errors occur. |
7. |
Click Include debug output in log to enable debugging level logging and upload the logs to the Appliance Logs page. |
8. |
◦ |
When the capture process is complete, a new system image entry appears on the System Images page in the KACE Systems Deployment Appliance Administrator Console, and also in the Remote Site Console, if the image is captured using an RSA. |
You can add the built-in Create Single Partition pre-installation task to create a single primary partition.
1. |
On the left navigation pane, click Library to expand the section, then click Pre-installation Tasks to display the Pre-installation Tasks page. |
2. |
3. |
5. |
6. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. 利用規約 プライバシー Cookie Preference Center