サポートと今すぐチャット
サポートとのチャット

DR Series DR4300 - Owner's Manual

DR4300 system overview Technical specifications Initial system setup and configuration Pre-operating system management applications
Options to manage the pre-operating system applications System Setup Dell Lifecycle Controller Boot Manager PXE boot
Installing and removing system components
Safety instructions Before working inside your system After working inside your system Recommended tools Front bezel (optional) System cover Cooling shroud Cooling fans Cooling-fan assembly System memory Processors and heat sinks PCIe card holder Cable retention bracket Integrated storage controller card Expansion cards and expansion card riser Internal dual SD module (optional) Network daughter card Internal USB memory key (optional) System battery Power supply units (PSU) System board Trusted Platform Module Hard drives Hard drive backplane SD vFlash card (optional) Control panel assembly
Using system diagnostics Jumpers and connectors Troubleshooting your system

Safety instructions

Installing and removing system components

Before working inside your system

For more information, see the Rack Installation placemat at Dell.com/poweredgemanuals.

After working inside your system

For more information, see the Rack Installation placemat at Dell.com/poweredgemanuals.

Recommended tools

You need the following tools to perform the removal and installation procedures:

This is needed only if your system includes a bezel.

You need the following tools to assemble the cables for a DC power supply unit.

関連ドキュメント

The document was helpful.

評価を選択

I easily found the information I needed.

評価を選択