maintenance --remote_access [--static_ip] [--ip <IPv4/IPv6 address>] [--netmask <netmask>] [--gateway <IPv4/IPv6 address>] [--device <lom1|lom2|lom3|lom4>] --static_ip Assign a static IP address for Integrated Dell Remote Access Controller (iDRAC). --ip Static IP address to use. --netmask Netmask for the assigned static IP address. --gateway Gateway for routing. --device Network device for iDRAC. By default, if you do not specify a device, the iDRAC port will be used.For example, to enable the remote access, you can run a similar command like the one below:
maintenance --remote_access --enable --static_ip --ip 10.250.241.167 --netmask 255.255.252.0 --gateway 10.250.240.1
Usage: maintenance --filesystem [--scan_status] [--scan_report [verbose]] [--repair_status [verbose]] [--repair_history [verbose]] [--scan_restart [verify_data | verify_rda_metadata | verify_metadata]] [--repair_now] [--reclaim_space] [--stop_reclaim_space] [--clear_quarantine] [--start_scan [verify_data | verify_rda_metadata | verify_metadata]] [--storage_group <name>] [--stop_scan] maintenance --configuration [--backup] [--restore] [--reinit_dictionary] maintenance --hardware [--reinit_nvram] [--restore_hw_db] [--network_reconfigure] [--motherboard_replaced] maintenance --disk [--make_standby [slot num]] [--type <internal | external-<num> | service tag>] [--clear_foreign] maintenance --remote_access [--show] [--enable] [--static_ip] [--ip <IPv4/IPv6 address>] [--netmask <netmask>] [--gateway <IPv4/IPv6 address>] [--device <lom1|lom2|lom3|lom4>] [--disable] maintenance --vdisk --check_consistency --type <boot | internal | external> [--service_tag <service tag>] maintenance --help maintenance <command> <command-arguments> <command> can be one of: --filesystem Maintenance operations on filesystem. --configuration Backup/Restore system configuration. --hardware Manage appliance hardware. --disk Manage disk drives. --remote_access Manage Integrated Remote Access Controller (iDRAC). --vdisk Manage virtual disk drives. For command-specific help, please type maintenance --help <command> eg: maintenance --help filesystem
© ALL RIGHTS RESERVED. 利用規約 プライバシー Cookie Preference Center