--create_bond --bondif <bondN> [--dhcp] [--static] --nwif <eth0,eth1,...,ethN> [--mode < ALB | 802.3ad>] [--name < DNS name >] [--mtu <Supported MTU range 512 - 9000>] [--ip <IPv4/IPv6 address not already in use>] [--netmask <netmask>] [--gateway <IPv4/IPv6 address>] [--restart] --bondif Bond interface to create. --dhcp Create dhcp interface. --static Create static interface. --nwif Eth interfaces to bond. --mode Bonding mode to use. --name DNS name for the interface. --mtu Ethernet MTU to use (valid range is 512 - 9000). --ip Static IP address to use. --netmask Netmask for the static IP address. --gateway Gateway for routing. --restart Restarts networking after creation.
For example, to create bond1 using eth3 and eth4, run the command: network --create_bond --bondif bond1 --dhcp --nwif eth3,eth4 --mode ALB --restart
Shutting down interface bond0: [ OK ] Shutting down interface bond1: [ OK ] Shutting down loopback interface: [ OK ] Bringing up loopback interface: [ OK ] Bringing up interface bond0:Determining IP information for bond0... done. [ OK ] Bringing up interface bond1:Determining IP information for bond1... done. [ OK ] Updating DNS entry for SW-01.local to 10.250.xxx.x .. Skipping DNS Update 10.250.xxx.x: IP already updated.
network --create_eth --nwif <ethN> [--dhcp] [--static] [--name < DNS name >] [--mtu <Supported MTU range 512 - 9000>] [--ip <IPv4/IPv6 address not already in use>] [--netmask <netmask>] [--restart] --nwif Eth interface to create. --dhcp Create dhcp interface. --static Create static interface. --name DNS name for the interface. --mtu Ethernet MTU to use (valid range is 512 - 9000). --ip Static IP address to use. --netmask Netmask for the static IP address. --restart Restarts networking after creation.
For example, to create eth2, run the command: network --create_eth --nwif eth2 --dhcp
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. 利用規約 プライバシー Cookie Preference Center