Rapid Recovery continues to enhance its Linux support by adding the ability to perform bare metal restore at the disk level of recovery points from agentlessly protected Hyper-V backups.
When using the Rapid Recovery Core console to perform the BMR, you can connect to the Linux Live DVD, and choose and map disks to restore.
Previously, when performing bare metal restore from the local_mount command line utility, volumes were identified by the drive letter, using alphabetic English characters.
In Rapid Recovery release 6.4, disk-level volumes are now numbered. Instead of using a lettered designation to specify a disk volume, you can specify the numbered disk volume. This change enables you to exceed 26 volumes (a restriction based on 26 alphabetic English characters).
The former command line syntax to restore using local_mount was:
mount <machine_line_item_number> <base_image_recovery_point_line_number> <volume_letter> <path>, where
When variables are replaced with sample values, this command appears as: mount 36 5 a /dev/sda1
Now in the command line you should specify the volume number, not letter. Thus the proper command to restore is now: r 36 5 1 /dev/sda1
The following enhancements have been added to Rapid Recovery 6.4, or were not previously documented in earlier releases.
VMware Workstation 15 now supported
Oracle VirtualBox 6.0 now supported
VM configuration backup and restore improvements on ESXi
Rapid Recovery Core supports specific versions of VMware Workstation as a target for one-time or continual virtual export.
VMware Workstation version 15 was released on September 24, 2018. Rapid Recovery Core release 6.4 has been fully tested with VMware Workstation version 15 and is fully supported for the near future.
In this release of Rapid Recovery, other support changes for VMware Workstation are applicable. For details, please see VMware Workstation support changes.
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback 利用規約 プライバシー Cookie Preference Center