Chatta subito con l'assistenza
Chat con il supporto

vRanger 7.6.4 - Integration Guide for DR Series Disk Backup Appliance

Getting started Understanding the Quest DR Series Installing and configuring your Quest DR Series Installing vRanger Maintaining your DR Series appliance About us

Installing and configuring your Quest DR Series

Previous Next



Installing and configuring your Quest DR Series

Installing the DR Series hardware

Prerequisites

Previous Next



Installing and configuring your Quest DR Series

Installing the DR Series hardware

Prerequisites

Previous Next


Installing and configuring your Quest DR Series > Prerequisites > Prerequisites

Prerequisites

Before installing the DR Series appliance, ensure that the following requirements have been met:

Subnet mask IP: 255.0.0.0
Default iDRAC IP: 192.168.0.120
NOTE: For iDRAC connection, the login name is root and password is calvin.

Installing the DR Series

Previous Next


Installing and configuring your Quest DR Series > Prerequisites > Installing the DR Series

Installing the DR Series

To install the DR Series appliance:

The connectors on the back of your system have icons indicating which cable to plug into each connector. Be sure to tighten any screws on the monitor’s cable connector.

5
Bend the system power cable or cables, as shown in the Quest DR Series Getting Started Guide, and attach to the cable strap.

The power indicator should light.

Related Documents

The document was helpful.

Seleziona valutazione

I easily found the information I needed.

Seleziona valutazione