1 |
Use the Schedule, Target Storage, and Advanced Options lists to configure any additional required options. |
2 |
TIP: To run a job that you have already created and saved, select Manage Job Definitions in the Navigation pane, select the applicable job, and click Run Now. |
WARNING:Before attempting to recover to the same disk that you backed up, verify that all existing partitions have been removed; otherwise, recovery to the same disk might fail, unless the data was backed up using Disk Raw Mode. Verify that the Disk Geometry of the OS targeted by the restore matches the geometry of the source OS that was backed up. If they do not match, for example, the source used 32 sectors per track, and the target uses 63 sectors, an error occurs when the system attempts to start. |
• |
• |
WARNING:Even if there is no difference between the system devices in a backup and a restore, the order of the disks might be different. If the restored data is started without performing a rename, any data that exists on the disks is lost. To compare the information of physical disk at backup and restore, note the Disk Geometry and Device Size at backup. For more information, see Performing a restore in which Disk Numbers are different from the backup. For version 1.1.6 and later, also compare the Disk ID of the targeted disk on the Create Selection Set page to the Disk ID of the same disk on the NetVault Backup Selections page. Dell strongly recommends that you disconnect all disks that contain critical data from the server before you boot the Plug-in Offline Client. |
2 |
Access the NetVault Backup Selections page to verify that the applicable client machine has been added as a NetVault Bare Metal Recovery Client. |
b |
c |
When the Edit Bare Metal Recovery Client dialog box appears, verify that the data is correct or change it as required. |
d |
If the NetVault Bare Metal Recovery Client is added correctly, skip to the Restore procedure for using Plug-in Offline Client to restore data to a physical machine section; otherwise, proceed to the next step. |
4 |
© ALL RIGHTS RESERVED. Termini di utilizzo Privacy Cookie Preference Center