To configure the DR Series system using the Backup Exec GUI, complete the following:
2. |
Select the server that you want to configure in the Backup Exec Services Manager page, and select Start all services. |
4. |
In the Connect to Media Server page, log into the media server, and enter a User name, a Password, and click OK. |
5. |
6. |
7. |
In the Account Credentials pane, enter the User name and Password account credentials for the DR Series system, and click OK (for example, the default user name is backup_user). |
8. |
In the Backup Exec Administrator page, click the Devices tab, and right-click on the local system name that is listed as the root node. |
9. |
10. |
◦ |
Server—enter the host name or IP address of the DR Series system. |
◦ |
Logon account—select the account from the drop-down list, which has credentials for accessing the DR Series system. |
◦ |
Server type—select the type of plug-in from the drop-down list (DELL OST plug-in). |
◦ |
Logical storage unit—enter the LSU (DR Series system container) name to use. |
11. |
Click Yes in response to the prompt about making the new device the default destination for new jobs. |
12. |
13. |
This topic describes how to use Backup Exec to create backups on the DR Series system.
To create backups on the DR Series system using Backup Exec, complete the following:
1. |
2. |
3. |
In the left navigation pane of the Backup Job Properties page, select Source, and select Selections. |
4. |
Select the system or node name in the center pane of the Selections page, and click the check boxes that correspond to the files you want backed up. |
5. |
In the left navigation pane of the Backup Job Properties page, select Destination, and select Device and Media. |
6. |
In the Device pane in the Device and Media page, select the DELL OST device in the drop-down list, and click Run Now to start the backup job. |
7. |
2. |
3. |
◦ |
Server—enter the host name or IP address of the DR Series system. |
◦ |
Logon account—select the account from the drop-down list (or click ... and browse to the account location), which has credentials for accessing the DR Series system. |
◦ |
Server type—select the type of server from the drop-down list (DELL). |
◦ |
Logical storage unit—enter the name of the logical storage unit (LSU), also known as a DR Series system container, to use. |
4. |
Click Yes in response to the prompt if you want to make the new device the default destination for new jobs. |
5. |
6. |
7. |
8. |
9. |
10. |
11. |
In Device, select the destination device from the drop-down list (that was created in this procedure), and click Run Now to start the replication operation between the two DR Series systems. |
12. |
This topic describes how to use Backup Exec to restore data from a DR Series system.
To restore data from a DR Series system using Backup Exec, complete the following:
2. |
3. |
4. |
5. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Termini di utilizzo Privacy Cookie Preference Center