Tchater maintenant avec le support
Tchattez avec un ingénieur du support

vRanger 7.8.5 - Integration Guide for NetVault SmartDisk

Getting started Understanding NetVault SmartDisk Planning your NetVault SmartDisk deployment Installing vRanger Installing NetVault SmartDisk Configuring NetVault SmartDisk Monitoring NetVault SmartDisk

Prerequisites for reinstalling NetVault SmartDisk

Ensure that the following prerequisites are met before reinstalling the NetVault SmartDisk software binaries.

The original identity.cfg configuration file is available. This file is located in the following directory:

Reinstalling NetVault SmartDisk if identity.cfg is available

If the original identity.cfg configuration file is available, reinstall the NetVault SmartDisk software binaries by performing the following steps:

During installation, enter the original values for the following options:
5
Replace the identity.cfg file with the original file.

Reinstalling NetVault SmartDisk if identity.cfg is not available

If the original identity.cfg configuration file is not available, reinstall the NetVault SmartDisk software binaries by performing the following steps:

Configuring NetVault SmartDisk

By default, NetVault SmartDisk uses port 37453 to communicate with vRanger instances that are streaming data to the NetVault SmartDisk Device. It also uses port 37451 for Inter Process Communication (IPC) on the loopback interface, but not for remote connections.

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation