Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Plug-in for VaultShare (ACSLS) 5.1 - Release Notes

Quest® NetVault® Backup Plug-in for VaultShare (ACSLS) 5.1

Quest® NetVault® Backup Plug‑in for VaultShare (ACSLS) 5.1
These release notes provide information about the Quest® NetVault® Backup Plug‑in for VaultShare (ACSLS) release.
Topics:
•
About this release
•
New features
•
Known issues
•
System requirements
•
Product licensing
•
Upgrade and installation instructions
•
More resources
•
Globalization
•
About us

About this release

Quest NetVault Backup (NetVault Backup) Plug‑in for VaultShare (ACSLS) (Plug‑in for VaultShare (ACSLS)) provides a device integration solution that lets you add and use library resources controlled by Oracle StorageTek Automated Cartridge System Library Software (ACSLS) in a NetVault Backup Domain.

Plug‑in for VaultShare (ACSLS) 5.1 is a minor release, with enhanced features and functionality. For complete product documentation, visit https://support.quest.com/technical-documents.

* 
IMPORTANT: Starting with 10.0, NetVault Backup provides a web-based user interface (WebUI) to configure, manage, and monitor your NetVault Backup system and installed plug-ins. The procedures described in the user’s guide for this version of the plug-in are intended for the new WebUI. For procedures based on the NetVault Backup Console (user interface available with NetVault Backup 9.x), see the documentation for an earlier version of the plug-in.

New features

New features in NetVault Backup Plug‑in for VaultShare (ACSLS) 5.1: Added support for the NetVault Backup WebUI.

Known issues

The following is a list of issues, including those issues attributed to third-party products, known to exist at the time of release.
Table 1. General known issues
Known issue
Issue ID

ACSLS limits the movement of 42 tape cartridges at one time. Therefore, the media count cannot exceed 42 for the Eject Media requests sent from the NetVault WebUI.

 

A log entry that should contain the text, “Backing off drive” is incorrectly translated, and reads as “Backup of Drive.”

18635

If a piece of media marked as “bad” is loaded into a tape drive, the tape drive goes offline and the media go into the “LOST” state rather than remain at the “BAD” state. The drive can be brought back online by using the Check command on the drive, but the media contained within remain unusable. The media is stuck in the drive and must be unloaded manually using the acssa CLI interface.

18580

Outils libre-service
Base de connaissances
Notifications et alertes
Support produits
Téléchargements de logiciels
Documentation technique
Forums utilisateurs
Didacticiels vidéo
Flux RSS
Nous contacter
Obtenir une assistance en matière de licence
Support Technique
Afficher tout
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation