Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Plug-in for SnapVault Manager 11.4.5 - Release Notes

Quest® NetVault® Backup Plug-in for SnapVault Manager 11.4.5

About this release

Quest NetVault Backup (NetVault Backup) Plug‑in for SnapVault Manager (Plug‑in for SnapVault Manager) provides a graphical interface that is integrated with the NetVault Backup WebUI to provide a single point of enterprise-wide control and improve the management of NetApp SnapVault solution. This feature lets you back up changed data from multiple storage platforms to a common Snapshot target on NetApp appliances, enabling faster tape less restores.

Plug‑in for SnapVault Manager 11.4.5 is a minor release.

Known issues

Table 1. Known issues

If you try to restore a non-qtree data directory, the job fails, but the job status shows “Restore Completed.”

NVBU-11148 (26968)

When relocating data during restore, if you include a trailing slash in the Relocate path, the restore job fails.

NVBU-11230 (27071)

On Windows, when you select the SV root directory for a restore job, plug-in restores the data successfully, but the job log includes the following error message:

Error Releasing Secondary Relationship: NDMP_SV_RPL_GENERIC

SnapVault: ERROR 1: The specified relationship is currently involved in a transfer. Release must be done on an idle or broken-off relationship.

Workaround: Release the relationship on the SV secondary filer. Use the snapvault destinations command to find the relationship that must be released.

DNSMP-115 (27020)

After importing a relationship, the plug-in does not display the relationship icon (“R”) on the selection tree until you refresh the Backup window.

NVBU-11245 (27086)

If you cancel a job during relationship initialization, the plug-in fails to remove the relationship. When you try to recreate the relationship, the plug-in displays the message “Relationship is busy.”

DNSMP-117 (27130)

Because all primary systems list the same number of snapshots whether they were taken for that primary system or not, the list contains both valid and invalid snapshots. When an invalid snapshot is selected for a restore, the job fails and logs show the message “No Path.”

DNSMP-118 (27154)

When restoring data to an open system, if you select the Restart Relationship check box, the job reports an error (“No common snapshot to use as the base for resynchronization”) and fails.

Workaround: Recreate the relationship after restoring the data.

DNSMP-119 (27156)

After relocating data to a new directory, the release statement fails and the job logs show the message “No release-able destination found that matches those parameters.”

This message can be ignored.

NVBU-11455 (27376)

System requirements

NetVault Backup versions

NetVault Backup 10.0 or later.

NetApp OSSV versions

NetApp OSSV 2.5 or later.

For complete supported-platform information, see the Quest NetVault Backup Compatibility Guide available at https://support.quest.com/technical-documents.

Outils libre-service
Base de connaissances
Notifications et alertes
Support produits
Téléchargements de logiciels
Documentation technique
Forums utilisateurs
Didacticiels vidéo
Flux RSS
Nous contacter
Obtenir une assistance en matière de licence
Support Technique
Afficher tout
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation