Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Plug-in for SnapMirror to Tape 10.0.5 - Release Notes

Dell™ NetVault™ Backup Plug‑in for SnapMirror® to Tape 10.0.5, Revision 1


These release notes provide information about the Dell™ NetVault™ Backup Plug‑in for SnapMirror® to Tape release.
•
About Dell NetVault Backup Plug‑in for SnapMirror to Tape 10.0.5
•
New features
•
Known issues
•
System requirements
•
Product licensing
•
Getting started with Plug‑in for SnapMirror to Tape 10.0.5
•
Globalization
•
About Dell

About Dell NetVault Backup Plug‑in for SnapMirror to Tape 10.0.5


Dell NetVault Backup Plug‑in for SnapMirror to Tape (Plug‑in for SnapMirror to Tape) provides block-level backups and improved disaster recovery support for data stored on NetApp filers. Working in conjunction with NetApp SnapMirror technology, the plug-in allows you to back up selected volumes or snapshots to tape devices for off-site storage. An intuitive, easy-to-use GUI gives you a single, centralized console to configure backup and restore policies for all your NetApp filers.
Dell NetVault Backup Plug‑in for SnapMirror to Tape 10.0.5 is a minor release.
 
 
*IMPORTANT: Starting with 10.0, NetVault Backup provides a web-based user interface to configure, manage, and monitor your NetVault Backup system and installed plug-ins. The procedures described in the user’s guide for this version of the plug-in are intended for the new NetVault WebUI. For procedures based on the NetVault Backup Console (user interface available with NetVault Backup 9.x), see the documentation for an earlier version of the plug-in.

New features


New features in Plug‑in for SnapMirror to Tape 10.0.5:
•
Added support for Data ONTAP 8.22 and Clustered Data ONTAP 8.3.
Currently BLI backups are not supported on Clustered Data ONTAP 8.3.

Resolved issues


The following is a list of issues addressed in this release.
 
Table 1. Resolved issues
Resolved issue
Issue ID
Corrected an issue that caused a BLI-based Incremental Backup to fail when the Create New Snapshot check option was selected and the Delete Previous Snapshot was not selected.
26015
Outils libre-service
Base de connaissances
Notifications et alertes
Support produits
Téléchargements de logiciels
Documentation technique
Forums utilisateurs
Didacticiels vidéo
Flux RSS
Nous contacter
Obtenir une assistance en matière de licence
Support Technique
Afficher tout
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation