1 |
In the vRanger UI, click My Repositories. |
2 |
On the toolbar, click Restore from Manifest, and then click Restore from Hyper-V Savepoint Manifest File. The Restore Wizard starts. |
3 |
Click Next. |
1 |
On the Savepoint Manifest Selection page, do one of the following: |
• |
Click Browse, and then browse to the location of the savepoint manifest. |
4 |
Click Add. |
6 |
Click Next. |
7 |
8 |
Click Next. |
a |
b |
Confirm that the path that appears in the Virtual Machine Location field is correct. To change this path, use the browse (…) button to locate and a select a new location. |
c |
Click the Master Disk Storage Datastore browse button to locate and select the datastore to use for all VMs. The Master Datastore lets you select all datastores simultaneously. |
d |
Click Assign. |
2 |
To select options for individual Hyper-V® VMs, do the following: |
b |
To select a different host for each VM, click the drop-down list in the Restore To Host column, and then select the host to which the VM should be restored. |
c |
To select a different datastore for each VM, click the button next to the Configuration File Location column entry. |
3 |
To rename to VM you are restoring, enter the new name under the Restore As column. |
4 |
Click Next. |
The Network Selection page lets you configure the virtual network to which each network adapters should be connected upon restore. You can configure a Master Network, which will be pre-populated as the default selection for each network adaptor in the restore job.
• |
To use the same network for all VMs, select a host from the Master Network drop-down list to which all VMs should be restored. Click Assign. |
• |
To use different networks for individual VMs, select a virtual network from the connected network adapters included in the Restore To Host drop-down list for each VM to which the vNIC should be connected. |
2 |
Click Next. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Conditions d’utilisation Confidentialité Cookie Preference Center