Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Plug-in for FileSystem 13.1 - User Guide

Exclusion list considerations

•
The Plug‑in for FileSystem supports the following special characters in an exclusion list.
 
Character
Description

/

Used to terminate Linux and UNIX file paths.

\

Used to terminate Windows file paths.

?

Used to match any one character.

!n

Used to insert new line.

!r

Used to insert carriage return.

!t

Used to insert tab.

!f

Used to insert form feed.

!b

Used to insert backspace,

!

Used to escape any special character that follows.

!!

Used to specify ! character in the filename or path.

•
File and directory names are case-sensitive on Linux and case-insensitive on Windows.
•
Spaces are not ignored.
•
To insert comments, use # at the starting of each line.
•
An exclusion list should not include any System State components on Windows, especially Windows File Protection and SYSVOL files on a Domain Controller.
•
An exclusion list cannot contain files or paths with non-ASCII characters. Such entries can cause a backup to fail.
•
Exclusion list is not supported for Off-Host backup.

 

Backing up data

•
About backup methods
•
About backup types
•
About System State Backups
•
About multistream backups
•
Backup and recovery strategy
•
Performing Full Backups
•
Inclusion lists
•
Additional notes
•
Performing Incremental and Differential Backups
•
Stopping a job
•
Restarting a job
•
Performing Network Share Backups
•
Performing System State Backups

Backing up with Plug-in for FileSystem

Backing up with Plug‑in for FileSystem

NetVault Plug‑in for FileSystem works with NetVault Server to back up sparse files and provide file-level recovery (FLR) of data backed up using continuous data protection (CDP).

About backup methods

The NetVault supports the following backup methods:

•
Standard Backup method: This method lets you perform native file system backups. The Standard Backup method is supported on all operating systems.
On Linux- and UNIX-based systems, only the Standard Backup method is available for backing up the file system data.
•
Snapshot-Based Backup method: This method lets you perform snapshot-based backups. A snapshot provides point-in-time copy of data. Snapshots enable consistent backups of data and minimize the time an application is in backup mode.
You can use the Snapshot-based Backup method to perform the following types of backups:
•
Use snapshots to perform consistent backups to disk- or tape-based storage devices.
•
Create and store snapshots as backups on supported disk arrays.
The snapshot-based method is only supported on Windows-based clients. For more information about supported OS versions and disk arrays, see the Quest NetVault Compatibility Guide.
 
* 
NOTE: The Backup Files to Storage is supported on any Windows platform and any disk storage. To use the Array-Based Persistent Snapshot and Discard After the data that you want to back up must reside on a supported disk array. Also, for persistent snapshot only backup, only metadata is copied to the target device and snapshot is created on storage array.
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation