Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Plug-in for FileSystem 13.1 - User Guide

About inclusion lists

An inclusion list is a text file that contains a list of files and directories that you want to include in a job. You can use any text editor to create this list. After creating the file, save it on the client to which you want to apply the list. On Linux and UNIX, save the file in multi-byte text format. On Windows, save the file in Unicode text format.

 
* 
NOTE: Inclusion lists are added on a per-job basis.

Inclusion list considerations

•
The maximum size of an inclusion list depends on how much memory is available to the backup process while it is running. It also depends on the system load at the time of backup. The list can still contain tens of thousands of entries on a small system to hundreds of thousands of entries on a 64-bit system with large memory configuration.
•
Provide the full file path for the file or directory that you want to include in a backup. An inclusion list does not support wildcards.
•
Specify one inclusion per line.
•
Inclusion lists cannot contain files or paths with non-ASCII characters. Such entries can cause a job to fail.
•
Inclusion list is not supported for Off-host backup.

Adding an inclusion list

To add an inclusion list:
1
On the NetVault Selections page, open the NetVault Client to which you want to add the inclusion list.
2
In the list of plug-ins, select File System, and click Show inclusion lists.
3
Open the Inclusion Lists node.
4
Use one of the following methods to add the inclusion list:
•
Select the file from the directory tree:
a
Open Browse for inclusion files.
b
Open the applicable nodes to display the directory that contains the inclusion list.
c
Select the check box corresponding to the Inclusion List.
•
Specify the file path:
a
Select Specify inclusion files and click Add inclusion file.
b
In the Enter path to inclusion file dialog box, type the file path for the inclusion list.
c
Click OK.
5
Save the Selection Set.

Removing an inclusion list

To remove an inclusion list:
1
On the NetVault Selections page, open the applicable NetVault machine.
2
In the list of plug-ins, select File System, and click Show inclusion lists.
3
Open the Inclusion Lists node.
4
Depending on the method used to add the Inclusion List, open Browse for inclusion files or Specify inclusion files. Open the directory tree, if applicable, and clear the check box corresponding to the Inclusion List.
5
Save the Selection Set.
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation