Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Bare Metal Recovery 13.1 - Release Notes for Windows Offline Client Plug-in

Quest® NetVault® Bare Metal Recovery Plug-in Offline Client for Windows PE 13.1

Quest® NetVault® Bare Metal Recovery Plug-in Offline Client for Windows PE 13.1
These release notes provide information about the Quest® NetVault® Bare Metal Recovery Plug-in Offline Client for Windows PE release.

About this release

NetVault Bare Metal Recovery Plug-in Offline Client for Windows PE 13.1 is a major release, with enhanced features and functionality. For complete product documentation, visit https://support.quest.com/technical-documents/.

Known issues

Backing up Dynamic Disks is only supported through Disk Raw Mode.

DNBMR-688 (17966, VDG‑252)

Restoring a GPT partition table to a larger disk results in a new partition that is the same size as the original: When a DR image is taken, the partition table is stored with it. At restore time, this partition is written to the new target disk and re-creates the original disk. If you restore to a disk that is larger than the original, the disk is partitioned to match the original size, which can result in unused disk space. For example, if you restore a 100GB image to a 200GB disk, it is partitioned for 100GB and leaves the extra space unused. You can use third-party partitioning tools, such as GNU Parted or PartitionMagic, to correct this issue.

DNBMR-689 (17967, VDG‑253)

Using the plug-in with NetVault Bare Metal Recovery Plug-in Offline Client for Windows PE 10.x: To complete a restore job in which the target contains a Unified Extensible Firmware Interface (UEFI) partition, use a blank disk. Windows PE does not include a tool that can be used to unmount the UEFI partition so that it can be overwritten during the restore; this issue causes restores to fail.

Workaround: Use NetVault Bare Metal Recovery Plug-in Offline Client for Windows PE 11.x or later.

DNBMR-958 (26597)

Performing restores of Raw format disks does not work.

Workaround: Use diskpart.exe to render the disk blank before beginning the restore and recovery process.

DNBMR-1205

System requirements

Before installing NetVault Bare Metal Recovery Plug-in Offline Client for Windows PE 13.1, ensure that your system meets the requirements outlined in the Quest NetVault Compatibility Guide available at https://support.quest.com/technical-documents/.
Outils libre-service
Base de connaissances
Notifications et alertes
Support produits
Téléchargements de logiciels
Documentation technique
Forums utilisateurs
Didacticiels vidéo
Flux RSS
Nous contacter
Obtenir une assistance en matière de licence
Support Technique
Afficher tout
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation