Booting the target server
This task is a procedure in Performing a full restore from manifest for a physical machine.
To boot the target server, complete one of the following procedures:
Booting into the restore environment using DHCP
To boot into the restore environment using DHCP:
When the boot is complete, a list of available network devices and their connection status appears.
▪ If no DHCP server is detected, each Ethernet device shows as “Disconnected.” Select the preferred network device. If only one device is present, it is automatically selected. Press Enter to select the highlighted network interface. You are then prompted to select either Use DHCP, which attempts to obtain an IP address again, or Configure Static IP.
3 [Optional] If the vRestore environment does not contain the correct drivers for your hardware, enter a Linux® command prompt by pressing F1, and add them manually.
Booting into the restore environment using static IP
To boot into the restore environment using static IP:
If only one device is present, it is automatically selected.
3 Press Enter to select the highlighted network interface.You are then prompted to select either Use DHCP, which attempts to obtain an IP address again, or Configure Static IP.
4 To configure a static IP address, select Configure Static IP.
5 In the Setting Static IP dialog box, enter the IP address, subnet mask, and gateway information, and then select Submit.The target server is configured with the selected IP information.
6 [Optional] If the vRestore environment does not contain the correct drivers for your hardware, enter a Linux® command prompt by pressing F1, and add them manually.
Creating a restore job
This task is a procedure in Performing a full restore from manifest for a physical machine.
To create a restore job:
1 In the main vRanger UI, click My Repositories.
2 On the toolbar, click Restore from Manifest, and then click Restore from Physical Savepoint Manifest File.
3
4 Click Next.
Selecting a savepoint from the manifest
This task is a procedure in Performing a full restore from manifest for a physical machine.
To select a savepoint from the manifest:
1 On the Savepoint Manifest Selection page, do one of the following:
▪ Click Browse, and then browse to the location of the savepoint manifest.
4 Click Add.
6 Click Next.
Mapping disks
This task is a procedure in Performing a full restore from manifest for a physical machine.
To map disks:
1 On the Disk Mapping page, in the Restore Machine IP Address box, enter the IP for the target server; for more information, see Booting the target server.
2 Click Map Disks.The page lists the disks in the chosen savepoint.
3 For each disk you want to recover, select the appropriate target disk in the Restore to Disk drop-down menu; for disks that you do not want to recover, select Skip this Disk.
4 Click Next.
© ALL RIGHTS RESERVED. Nutzungsbedingungen Datenschutz Cookie Preference Center