Configuring email notifications
To add or edit email addresses, see Setting up the SMTP server.
To configure email notifications:
1 On the Email Notification Selection page, in the Selected column, select the address to which notifications should be sent.
2 Click Next.
Starting the restore job
The final page in the Restore Wizard displays a summary of the selections you made for the job.
To start the restore job:
1 On the Summary page, review the data displayed in the tree view.
2 If you want to begin the job automatically after completing the wizard, select Run the Job after Finish is clicked.
3 Click Finish.
b
c
5
Performing a full restore from manifest for a physical machine
To perform a full restore from a manifest for a physical machine, complete the following tasks:
Creating the boot media
To restore a savepoint to a physical machine, you must first boot the target server into the vRanger restore environment using the vRanger Restore images — ISO for CD, IMG for a bootable USB drive. You can download the restore image files — vzRestore-<version>.iso and vzRestore-<version>.img — from the Quest website.
This task is a procedure in Performing a full restore from manifest for a physical machine.
To create the boot media, complete one of the following procedures:
Creating a bootable CD
Complete the steps in the following procedure to create a bootable CD.
IMPORTANT: The procedures for creating a bootable CD differ widely depending on the operating system and software used. The following procedures show how to use the native Windows® 7 utility to create a bootable CD. If you have a different image burning application, follow the instructions for that application.
To create a bootable CD:
2
3
4
6 Click Burn.Creating a bootable USB drive
Complete the steps in the following procedure to create a bootable USB drive.
NOTE: There are no native Windows® utilities for creating a bootable USB drive from an IMG file. The following procedure was created using a freeware application, Image Writer for Windows. Follow the instructions for your application.To create a bootable USB drive:
2
3
4
5 In the Device drop-down list, ensure that the correct USB drive is selected.
6 Click Write.
7 Click Exit.
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Nutzungsbedingungen Datenschutz Cookie Preference Center