Perform the following steps on the primary node.
1 |
In the Navigation pane of the NetVault Backup WebUI on the NetVault Backup Server, click Create Backup Job, and click Create New next to the Selections list. |
3 |
4 |
5 |
On the Configure dialog box, set the applicable configuration options. |
IMPORTANT: Add each cluster instance in the Instances field of the Configure dialog box. To add an instance, specify the MySQL Clustered Service name as VIRTUAL SERVER NAME\INSTANCE NAME. |
Open the Plug‑in for MySQL node on the NetVault Backup Selections page, and select the MySQL Server Virtual Server, or the items contained within, for inclusion in the backup.
The instance name displayed in this page is actually the MySQL Clustered Service. If other MySQL Server Clustered Services are running on this node, those instances are also displayed within the Plug‑in for MySQL node. Data from these other instances must not be selected for inclusion in the backup.
All options available for a restore with Plug‑in for MySQL are also available for Failover Clustering environments, and data selection is performed in the same way. The only difference is that restorable backups are displayed on the Create Restore Job — Choose Saveset page under the name of the primary node that was active during each backup. When a restore job is initiated, NetVault Backup communicates with all member Clients to determine which machine is in control of the failover cluster, and then targets this machine for the restore.
All the instructions offered for performing a restore can be used in the recovery of a failover cluster. For more information, see the various topics in Restoring Data. To restore a failover cluster to a standalone NetVault Backup Client, use the instructions provided in Recovering to an Alternate MySQL Server.
NetVault Backup 10.x service (netvault-pgsql) does not start on Windows |
NetVault Backup 10.x uses a PostgreSQL database. If the PostgreSQL database does not start, NetVault Backup cannot start. To correct this issue, delete the “postmaster.pid” file from the location referenced in the log and restart the NetVault Backup Server. For more information, see https://support.quest.com/netvault-backup/kb/122475. |
Access the Manage Devices page of the NetVault Backup WebUI, and perform a scan of the media targeted by the job. NetVault Backup stores index information for backup jobs in two locations: in the NetVault Database and on the media targeted by the backup. Performing this scan adds the index information to the NetVault Database. To verify that the information was added, open the Create Restore Job — Choose Saveset page and locate the specific job. If you can browse it and set up a restore job, the scan process has corrected the problem. | |
If a backup fails with a message similar to “Failed to start Replication slave server,” it might indicate that you selected the Enable MySQL Replication check box but did not configure replication. To correct this issue, either clear the Enable MySQL Replication check box on the Configure dialog box or set up replication, and then run the backup job again. For more information about updating the configuration, see Configuring the plug-in; for more information about replication, see Working with native MySQL replication. | |
In a Linux or UNIX environment, a backup or restore job fails with the following error: |
For more information about updating the path and filename, see Configuring the plug-in. |
© ALL RIGHTS RESERVED. Feedback 使用条款 隐私 Cookie Preference Center