立即与支持人员聊天
与支持团队交流

NetVault Plug-in for Hyper-V 11.2 - Release Notes

Obtaining a machine ID

1
Start the NetVault Backup WebUI.
2
In the Navigation pane, click Manage Clients.
3
In the NetVault Backup Clients list, select the applicable machine, and click Manage.
4
On the View Client page, note the machine ID exactly as it is displayed in the Client Summary table.

Installing a license key using the configuration wizard

1
In the Navigation pane, click Guided Configuration.
2
On the NetVault Configuration Wizard page, click Install Licenses.
3
In the NetVault Backup Clients list, select the applicable machine, and click Next.
4
In the Enter the license key string box, type or copy and paste the license key, and click Apply.
After the key is applied successfully, a message is displayed.

Installing a license key from the Manage Clients page

1
In the Navigation pane, click Manage Clients.
2
In the NetVault Backup Clients list, select the applicable machine, and click Manage.
3
On the View Client page, click Install License.
4
In the Install License dialog box, type or copy and paste the license key, and click Apply.
After the key is applied successfully, a message is displayed.
5
To dismiss the dialog box, click Close.

Upgrade and installation instructions

For upgrade and installation instructions, see the Quest NetVault Backup Plug‑in for Hyper‑V User’s Guide.

Important upgrade and installation notes

Before installing or upgrading the plug-in, review the following items:

•
If you are upgrading from version 1.7 or earlier, you must remove the existing plug-in and upgrade to NetVault Backup 10.0.5 or later before you install the new version. The name of the plug-in was changed in version 10.0.1. This process ensures that items with the previous plug-in name are removed before items with the new name are installed.
•
If you are upgrading from version 10.0.1 and your environment contains a Hyper-V Cluster on the physical client, the upgrade process automatically removes the configured cluster; that is, it removes the server and credential information from the configuration file for the plug-in. The upgrade assumes that you intend to add a Virtual Client and configure the cluster again. Due to the introduction of the Virtual Client functionality, also delete backup jobs created for a cluster in version 10.0.1, and re-create the jobs using the new version.
•
If you intend to use the NetVault Backup Virtual Client functionality, do not complete the following procedures. The process of creating and using the Virtual Client automatically pushes the plug-in to the applicable physical clients. For complete information about using Virtual Clients, see the Quest NetVault Backup Administrator’s Guide.
相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级