立即与支持人员聊天
与支持团队交流

NetVault Plug-in for Exchange 11.0 - User Guide

Introducing Dell™ NetVault™ Backup Plug-in for Exchange Defining an Exchange data protection strategy Planning your Exchange Server deployment Installing and removing the plug-in Configuring the plug-in Backing up data Restoring data Troubleshooting

Enabling services

In Windows® Control Panel > Administrative > Services for the Exchange Mailbox Servers, verify that the following services are enabled and running:
Microsoft Exchange Replication Service — required in DAG, LCR, and CCR environments
Volume Shadow Copy — started automatically by Microsoft Software Shadow Copy Provider

Configuring localization settings

The plug-in uses traditional Windows® code page selection to enable localization, and is therefore subject to certain limitations. The plug-in must be used in an environment with correctly configured localizations settings to function properly.

Configuring the Windows Active Code Page

1
Open the Windows® Control Panel.
2
Select Regional and Language Options.
3
Select the Advanced tab.
4
In the Select a language to match the language version of the non-Unicode programs you want to use list, select the correct language.

Configuring a NetVault Backup Server or Client

2
On the Configuration page, click Server Settings or Client Settings, whichever is applicable.
3
Under System and Security, click General.
4
In the Language Selection list, select the applicable language, and then click Apply.
相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级