立即与支持人员聊天
与支持团队交流

NetVault Plug-in for NDMP 10.0.5 - User Guide

Configuring NetVault Backup user account

1
Start the Backup Job Wizard, and click Create New next to the Selections list.
3
Select the filer, and in the Actions list, click Set Account.
4
In the NetVault Account dialog box, provide the following information:
Account: Type “default”, which is the user account used to run the subjobs.
New Password: Select the New Password check box, and specify the password set for the “default” account.
5
Click OK to save the information.

Configuring default settings

1
Start the Backup Job Wizard, and click Create New next to the Selections list. Open the NetVault Backup Server. Select NDMP Client, and in the Actions list, click Configure.
In the Navigation pane, click Change Settings. On the Configuration page, click Server Settings, and then click Plugin Options.
2
Under NDMP Backup Log Filters, configure the following settings:
You can use these settings to filter log messages generated during backup jobs. The messages that contain the strings specified in these boxes are not displayed on the View Logs page. Each box can contain one filter string. Thus, you can specify a maximum of 10 filter strings in the filter boxes.
3
Under NDMP Backup Configuration, configure the following settings.
4
Under NDMP Restore Log Filters, configure the following settings:
You can use these settings to filter log messages generated during restore jobs. The messages that contain the strings specified in these boxes are not displayed on the View Logs page. Each box can contain one filter string. Thus, you can specify a maximum of 10 filter strings in the filter boxes.
5
Click OK to save the settings and close the dialog box.

Configuring filer-attached devices

相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级