立即与支持人员聊天
与支持团队交流

vRanger 7.8.4 - User Guide

Introduction vRanger overview Configuring vRanger
Configuring vRanger through the Startup Wizard Configuring vRanger manually Supplemental instructions: additional repository types
Using vRanger Backup Restore
Restoring an encrypted VMware VM Performing a full restore for VMware VMs Performing a full restore for Hyper-V® VMs Performing a full restore for VMware vApps Performing a full restore of a physical machine Performing an FLR on Windows Performing an FLR on Linux Restoring from manifest
Replicate VMs Reports Integrating and monitoring vRanger Using the vRanger Console vAPI Cmdlet details

Logging in to the VA

Complete the steps in the following procedure to log in to the VA.

To log in to the VA:
1
From your VI Client, find the VA, and power it on.
2
Using the console, log in as root to the VA, using the following default credentials:
•
Username: root
•
Password: vzroot1
If you supplied your own password during the VA deployment, use that password.

Changing the hostname

Complete the steps in the following procedure to change hostname.

To change the hostname:
1
Log in to the VA.
2
Using the VI text editor, edit the network configuration file:
vi /etc/sysconfig/network
3
Change the hostname to the new value, and save the file.
4
Restart the VM by typing reboot at the prompt.

Changing the network configuration

Optionally, you can complete the steps in the following procedure to change the network configuration.

To change the network configuration:
1
Log in to the VA.
2
Using the VI text editor, edit the configuration file for eth0:
vi /etc/sysconfig/ifconfig.eth0
3
Edit the configuration file as needed.
The following text is shown as an example:
ONBOOT=yes
SERVICE=ipv4-static
IFACE=eth0
IP=<static IP of VA>
GATEWAY=<IP of gateway>
PREFIX=<this entry is the subnet mask — your values may differ>
BROADCAST=<your broadcast IP — the highest IP in the VA’s subnet.>
4
Save the file.
5
Restart the VM by typing reboot at the prompt.

Configuring DNS

Depending on your environment, you might have to configure the VA with DNS nameserver information. The steps to change an existing configuration are the same.

To configure DNS:
1
Log in to the VA.
2
Using the VI text editor, edit the resolv.conf file:
vi /etc/resolv.conf
3
Enter the following text, substituting the appropriate values where indicated:
search <domain1> <domain2> <domain3>
nameserver <IP address>
nameserver <IP address>
4
Save the file.
5
Restart the VA by typing reboot at the prompt.
相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级