This section describes how to set the required permissions for the Agent Host Account used by Migration Manager for Exchange agents. This account is used to install and run Migration Manager for Exchange agents on agent hosts and to access the license server. The required privileges for the Agent Host Account are as follows:
|
NOTE: By default each Exchange server is an agent host for itself. If you use the default agent host then to simplify the account setup process, you can grant these permissions to the Exchange Account and use it instead of the Agent Host Account. |
To set up the Agent Host Account, perform the steps described in the related subtopics.
|
nOTE: Note that the steps are given only as an example of a possible Agent Host Account setup. |
The default Source Agents Host Account (initially displayed on the Default Agent Host page of the Exchange server Properties) is set when you add the source organization to migration project (see the Registering Source and Target Organizations section of the Migration Manager for Exchange User Guide for details).
If necessary, you can change the default Source Agent Host Account by clicking Modify on the General | Default Agent Host page of the corresponding source server properties in the Migration Manager for Exchange Console.
To go on using the default Source Agent Host Account for Exchange migration, grant the permissions required for Exchange migration to this account (see the next steps).
The Source Agent Host Account should be a member of the local Administrators group on the license server (unless alternative credentials are used for the license server).
|
Caution:
|
To add the Source Agents Host Account to the local Administrators group on the license server perform the following:
Close the dialog boxes by clicking OK.
Perform the steps described in the related subtopics to ensure that your Exchange environment is ready for migration:
© ALL RIGHTS RESERVED. Feedback 使用条款 隐私 Cookie Preference Center