Getting started with Foglight for Office 365
Administering monitoring agents and collected data
Accessing the Administration tab
Deploy the Foglight for Office 365 agent package
Managing Foglight for Office 365 agents
Monitoring your environment
Foglight for Office 365 views
Add and configure Foglight for Office 365 agents
Activate, deactivate, and delete agents
Start and stop data collection
Configure domain credentials
Set up permissions to use the Office 365 APIs
Configuring Foglight for Office 365 agent properties
Managing ADFS agents
Configuring ADFS agent properties
Managing certificates
Add a certificate
bin/fglam --add-certificate "user alias 1"=/path/to/certificate/file
|
• |
FglAM requires the Base64 format. To verify if the certificate file is encoded with Base64, open the certificate with a notepad and the certificate should be similar to the following example: -----BEGIN CERTIFICATE----- XXXXXXXX= -----END CERTIFICATE----- |
|
NOTE: If the certificate is not Base64 format, use openssl command to convert the certificate file into a Base64 file. Use either of the following commands depending on the source form: openssl x509 -inform DER -in xxx.cer -out xxx.crt or openssl x509 -inform PEM -in xxx.cer -out xxx.crt |
|
• |
The alias is required and is used in the list and delete operations to refer to the certificate. It can be anything. |
List installed certificates
Print out a list of certificates and the aliases that refer to them.
Refer to the example output below:
Delete a certificate
Remove a certificate referred to by an alias.
bin/fglam --delete-certificate "user alias 1"