Chat now with support
Chat with Support

NetVault Plug-in for NDMP 10.0.5 - Application Notes for Oracle NAS 7000

Installation and configuration prerequisites

•
Installation prerequisites
•
Configuration prerequisites

Installation prerequisites

In addition to the prerequisites covered in the Dell NetVault Backup Plug-in for NDMP User’s Guide, verify that the following requirements are met:
•
Hardware requirements: For information about Hitachi NAS (HNAS) Servers, see the Hitachi Data Systems website at: https://www.oracle.com
•
Software requirements: For information about software requirements and supported filer operating systems, see the Dell NetVault Backup Compatibility Guide available at: https://support.quest.com/
 
 
*NOTE: The installation and configuration procedures are described in the Dell NetVault Backup User’s Guide.

Configuration prerequisites

In addition to the prerequisites covered in the Dell NetVault Backup Plug-in for NDMP User’s Guide, verify that the following requirements are met:
•
User account for NDMP backups and restores: From the administration interface, assign a DMA user name and password for NDMP backups and restores. Consult the relevant filer documentation for instructions on creating a user account.
Use this account when adding the NDMP Server to the plug-in.
•
Direct Access Recovery (DAR) requirements: To use DAR, enable this feature on the filer.
•
DMA Tape Mode Setting: Set the NDMP Service “DMA Tape Mode” to BSD on the filer.
 

Backing up data

•
About Backup Dump Levels
•
Backing up data using the plug-in
•
Backing up individual data paths
Related Documents

The document was helpful.

Select Rating

I easily found the information I needed.

Select Rating